We had a question from our customers if the Snowboard can be used with a single zone FSR (force sensing resistor) sensor. An answer was given in our last blog post and today we will go further with this issue. Shortly speaking, the Snowboard can work with upto 160 single zone FSR sensors. All you need to do is to connect two ends of a sensor to appropriate pins of the Snowboard - One end to D pin and the other to A pin. D pins and A pins are configured as shown in the picture below: In this post, we will add 3 single zone FSR sensors to the Snowboard. Add them, upload a firmware and run a visualization application according to this instruction. Press each sensor and you can see the visual response of each sensor. When you touch all of these sensors, the Snowboard can measure their responses simultaneously.
0 Comments
Leave a Reply. |
Archives
May 2022
Categories |